There are several places where you can search for the information you are looking for. Below you can find some of them Webcast  and Videos                   http://www.open-e.com/service-and-support/library/webcasts-and-videos/ ...

I've installed DSS no my XEN server. After reboot it's loosing activated status. What should I do?  Solution: Find unique dss.cfg* file of your VM with DSS and add following line to the file: uuid = '54443858-4E54-2500-904C-0025904C93D8' ** *where dss is name of your VM **Where ...

Can I remove logical volume without restart of Open-E? Solution: Yes you can. You just have to perform few actions via the WebGUI: -          make sure that volume is not assigned to any target or shares...

 It may happen that the following warning will appear in the DSS V6 event viewer and in the dmesg logs: CONFIG_TCP_ZERO_COPY_TRANSFER_COMPLETION_NOTIFICATION not enabled in your kernel. ISCSI-SCST will be working with not the best performance. Refer README file for details. But it doesn't...

Function: Failover Manager The failover manager provides an overview of the cluster configuration and allows starting and stopping the cluster. start Start button is shown when the failover hasn't been started. Use it to start the failover process. When the configuration verification mechanism is...

WWN - Worldwide name, this is a unique identifier in a Fibre Channel storage network. Each WWN has a fixed 64-bit name assigned by the manufacturer and registered with the IEEE to ensure that it is globally unique. It may only include characters from A to F, a to f, digits from 0 to 9 and the :...

Function: S/W RAID e-mail notification It is possible to send notification via e-mail about events on software RAID arrays (e.g. rebuild started, rebuild finished, RAID degraded). In order to do so, please check the Send array events box. NOTE: In order to be able to send array events via e-mail...

If your system has a hardware RAID, please create a RAID array in the RAID controller setup. Please refer to the RAID controller manual. You do not have to install drivers or RAID array monitoring and maintenance software. If your system has motherboard RAID functionality, please do not use it as...

 Adding Disk Array    - In the menu, please select “CONFIGURATION” -> ”volume manager” and “Unit manager”.    - You will find a list of available drives/arrays (units) that can be used.    - When creating a new volume group, the system adds...

After creating an iSCSI volume, please choose “CONFIGURATION” -> ” iSCSI target manager” -> ”Targets” and within the “Create new target” function click the “Apply” button to create a new iSCSI target. Next, in the “Targets” diagram click on the name of a target you...