1.      1. Find out the UPS IP address from the DHCP server. (in this how-to : 192.168.0.156) 2.      2. Go to the UPS WEB GUI http:// 192.168.0.156 address: default user name: admin  password: public 3.      3. In the...

NOTE: This solution is for DSS V7 system This issue was observed on some Supermicro motherboards: NIC is not visible in DSS for configuration, but the driver is loaded and card information can be seen. To fix it, enter BIOS > "Advanced Chipset Configuration" > "Enable VT-d" and change...

Problem: - high cpu usage after update to the DSS V7 up53, - multicore CPU visible as one core CPU in the log file: tests.log Solution: - turning off X2APIC settings in the mainboard BIOS, X2APIC is not supported by DSS kernel Problem occured on HP GEN9 server but it is...

The problem is that the Firefox upgrade v34 and higher is disabling SSL v3. Current DSS V7 versions does not have this problem as default Security protocol is set to “Automatic” (SSL v3 + TLS), but some older DSS versions or updated from older may have this problem. To fix the problem with...

We want to thank the PAConnect Team for the hard work on putting this together and contributing this for everyone to use as a guide. Written and developed by: Kenneth Lindsay & Jessy Marker MCSE,MCTS,ACE www.paconnect.com Infiniband for VMWare   * Download PuTTY and WinSCP,...

 Yes, but you need to apply the small update. It suits to DSS V7 up00 and up01. In later versions the driver will be included.

You can upgrade your DSSv6 Lite build to be a Full DSSv6 by typing the PK (Product Key) for DSSv6 Full version, into the Lite DSSv6, and the system should work as DSSv6 Full version after reboot . To upgrade your license key from DSSv6 Lite to a Full DSSv6, please visit the following link : ...

If you are facing licensing issues with DSS V6 that runs on the following Supermicro motherboards: X8DT3/I X8DT6/E X8DTT X8DTN+ please update the BIOS to the newest version or at least to the one that can be found in the attachment (X8DT60.zip). DSS V6 uses motherboard ID’s to...

In case you have a mother board that will not install with DSS V6: The workaround is to remove "nousb2" from boot loader command line (by pressing TAB on the "Run Software Installer" entry, editing the line by removing "nousb2" and after complete just press "Enter"). NOTE: this has been removed...

In case you are having issues with booting fully with the DSS V6 due to some newer motherboards please try the following. Select (highlight) the “run software installer” and THEN press TAB key. Then modify following boot parameters: vmlinuz3 change to> vmlinuz4 initrd3.gz change...