Open-E Knowledgebase

DSS V6: Both nodes failure

Article ID: 1973
Last updated: 29 Jan, 2013

If both of your nodes has failed/restarted first thing to do is to check if data on both servers is consistent.

Now you can start restoring configuration. In order to do that we have two possible solutions:

First solution:

go to the Primary node:

SETUP-> network-> Failover-> Function: Failover Manager click Stop and wait until the process will be finished. After that click Start and wait a second so the nodes can configure themselves again

Second solution:

go to Secondary node:

SETUP-> network-> Failover-> Function: Failover Manager
  and click Sync volumes. After this process is finished click Failback.
If there are no other problems your failover should be running now.

This article was:   Helpful | Not helpful Report an issue


Article ID: 1973
Last updated: 29 Jan, 2013
Revision: 1
Views: 1111
Posted: 25 Jan, 2013 by --
Updated: 29 Jan, 2013 by
print  Print email  Subscribe email  Email to friend share  Share pool  Add to pool
Prev     Next
DSS V7: One of the nodes failed in Active- Active configuration       DSS V6: Primary/Active node failure in failover

The Knowledge base is managed by Open-E data storage software company.