Open-E Knowledgebase
Search:     Advanced search

Configuring LSI RAID Controller alerts sent to DSS V7

Article ID: 1693
Last updated: 28 Mar, 2013
Views: 7628
Configuring LSI RAID Controller alerts sent to DSS V7 Rating: 8.0000 / 10
Votes: 8
Posted: 10 Aug, 2012
by:
Updated: 28 Mar, 2013
by:

Configuring LSI RAID Controller alerts sent to DSS V7

Alerts sent to DSS V7 from the LSI MegaRAID Controller can be enabled, or disabled in the following categories: Information, Critical, and Fatal.
To do this, you may disable them, by category, or individually, from the 'System Log' on the controller. To do this, you need use MegaRAID Storage Manager and go to Tools -> Configure Alerts -> Alert settings and enable/disable "System log" for desired category. Please refer to attached screenshot.

If you disable sending the event(or category of events) to the 'System log', The DSS V7 will not recieve the message, will not send it to the event viewer, and will not send an email alert.

This article was:   Excellent | Very Good | Good | Fair | Poor
Attached files
file msm.jpg (240 kb)

Also listed in
folder Information -> General info -> RAID

Prev   Next
How to setup email notification using Megaraid Storage Manager     VMware: Problems with DirectPath RAID Controller ( passthrough )

The Knowledge base is managed by Open-E data storage software company.
RSS